About

This toolkit builds applications based on CDP 4.10 and later for the INSYS icom SmartBox series devices.

Information about how to deploy applications can be found in the Deploy Configuration.

Supported devices

This toolkit supports INSYS icom ARMv7 32bit based platforms such as MRX, MRO, ECR and SCR. The toolkit might also support other ARMv7 32-bit devices that runs a Linux Operating System that satisfies the Dependencies in the table below.

Dependencies

The toolkit builds for INSYS SmartBox containing the following package versions:

Architecture

This toolkit targets an INSYS icom SmartBox on ARMv7 and built binaries will thus not run on x86 based platforms.

Web Page

Click here to go to the INSYS icom web page, where you can find information about the hardware, and a selection of linux-containers that can be run on the target.

Using the Toolkit Outside CDP Studio

The following paths and build commands are required to build a CDP Studio project in a Windows command prompt (using this toolkit):

SET WORKSPACE=C:\CDPStudioWorkspace
SET TOOLKITDIR=C:\CDPStudio\toolkits\insys_smartbox_armv7_13
SET QTDIR=%TOOLKITDIR%\Qt-5.13
SET INSTALL_ROOT=C:\build
SET QMAKEFEATURES=%TOOLKITDIR%\CDP-4.10\qmakefeatures;%WORKSPACE%\deployments\libraries\<toolkit>\qmakefeatures;%INSTALL_ROOT%\qmakefeatures
SET PATH=%TOOLKITDIR%\toolchain\bin;%QTDIR%\bin;%PATH%
qmake && mingw32-make

To use the above in a Linux shell we have to make some small adjustments:

export WORKSPACE=$HOME/CDPStudioWorkspace
export TOOLKITDIR=$HOME/CDPStudio/toolkits/insys_smartbox_armv7_13
export QTDIR=$TOOLKITDIR/Qt-5.13
export INSTALL_ROOT=$HOME/build
export QMAKEFEATURES=$TOOLKITDIR/CDP-4.10/qmakefeatures:$WORKSPACE/deployments/libraries/<toolkit>/qmakefeatures:$INSTALL_ROOT/qmakefeatures
export PATH=$TOOLKITDIR/toolchain/bin:$QTDIR/bin:$PATH
qmake && make